.: Ambient Door Pocket Lighting

 

Pocket Lighting Coding for non Ambient Lighting.

 

The final page but probably the first step you should take is the coding. This will allow you to confirm your module is good to go and that way you can test each door as you put it back together. Note that these may have already been selected depending on your car options.

Front Doors:

[ECU 42 and 52]
[Coding - 07] -> [Long Coding Helper] -> Byte 1 Bit -> 2 Change 0 to 1
Or Check the box for “Door Warning Lights installed”

[ECU 42 and 52]
[Coding - 07] -> [Long Coding Helper] -> Byte 1 Bit -> 3 Change 0 to 1
Or Check the box for “Interior Door Handle Illumination installed”

Here is a picture showing the module and items selected.

Rear Doors:

[ECU 62 and 72]
[Coding - 07] -> [Long Coding Helper] -> Byte 1 Bit -> 2 Change 0 to 1
Or Check the box for “Door Warning Lights installed”

[ECU 62 and 72]
[Coding - 07] -> [Long Coding Helper] -> Byte 1 Bit -> 3 Change 0 to 1
Or Check the box for “Interior Door Handle Illumination installed”

Here is a picture showing the module and items selected.

Complete your coding and your all done.

Enjoy your new lights.

Here are a few early test pictures while working on the project and lights. These are using the factory LED lights. The colour of the light is really hard to capture but just look at your factory LED lights and you'll know the true colour.